HOW TO USE

Follow these step-by-step directions when using
E-6000® Series of Industrial Strength Adhesives:

1. Use in a well-ventilated area only. Surface should be clean, dry and free from dirt. Roughen surface before use. Best when used between 70 °F (21°C) and 85 °F (29 °C).
2. Apply E-6000 directly to the area to be repaired. For maximum strength, allow bond to dry for 24-72 hours. Cure time increases with lower temperatures and decreases with higher temperatures. Set on low and do not hold directly on E-6000.
3. Clean uncured adhesive with acetone or naphtha. Cured material may be removed by cutting and scraping.
4. E-6000 is not recommended for use on Styrofoam^™, polystyrene, polyethylene or polypropylene plastics.

For technical support, contact our Technical Service Department by mail, email, or phone. Our office hours are 7:30 A.M. - 4:00 P.M. (Central) Monday through Friday. Please contact us for more information.

To request a Material Safety Data Sheet (MSDS) please send an email to msds@eclecticproducts.com