Check out our other
epoxy products:

    SuperMEND®

    Marine

    Automotive

    Coat-It®

Anti-Skid Epoxy with Grit —
All Purpose and Bath, Tub & Tile

How To Use

• Surface should be dry, clean and free of oil, wax, dirt, loose paint and other contaminants. If necessary, remove all the old paint down to the original surface. Aluminum surfaces should be treated first before applying Amazing GOOP Anti-Skid Epoxy. Wood surfaces should be primed with an oil based primer. Test a small area for color compatibility and adhesion.
• For best results, spray between 70 and 90 °F/21 and 32 °C. Applying Amazing GOOP Anti-Skid Epoxy below 50 °F/10 °C will cause the paint to spray or dry improperly.
• Mix contents of can well by shaking for 2-3 minutes. Mixing ball will roll freely when properly mixed. Continue to shake can intermittently for 10 seconds during use.
• To apply, spray in a sweeping motion 12 to 15 inches away from surface.
• IMPORTANT: Clean valve immediately after each use. Hold can upside down and spray until only clear gas comes out (3-5 seconds). If spray valve becomes clogged, pull off and clean in lacquer thinner.

Surface Preparation Instructions

Refer to the Amazing GOOP Anti-Skid Epoxy Technical Data Sheet for information on: Metal, Wood, Tile, Porcelain, Concrete, Fiberglass, Unpainted, or Painted Aluminum.

Clean Up

Overspray can be removed with paint or lacquer thinner.

Find out more:
Amazing GOOP Anti-Skid Epoxy
Troubleshooting Tip: Spray Nozzle
Product Video
Sell Sheet (All Purpose)
Sell Sheet (Bath, Tub & Tile)
Technical Data Sheet (TDS)
Anti-Skid with Grit MSDS — EN